|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
March 13th 08, 08:22 PM
posted to microsoft.public.outlook.program_vba
|
|||
|
|||
Error "The operation failed" occurs only when Outlook is closed.
I'm using Visual Basic to create and send a message thru Outlook 2003. It
has worked perfectly for over a year at multiple sites, and works whether or not the user has Outlook open. However, I have one site where an error occurs only if Outlook is closed. If Outlook is open, the message is sent just fine. If Outlook is closed, the user recieves an error message "The operation failed" upon execution of the following line: Set objOutlookMailItem = objOutlook.CreateItem(olMailItem) This is very perplexing because it is only happening at one of over 100 sites. Any help will be greatly appreciated. Thanks. 
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "Operation Failed" error message | Scoopwash | Outlook - Using Contacts | 2 | November 26th 07 04:15 AM |
| Send/receive error: "Operation failed. Object could not be found" | RC in Washington | Outlook - Installation | 0 | June 25th 07 05:41 AM |
| "operation failed" error | Mark | Outlook - General Queries | 1 | June 4th 07 04:49 PM |
| "operation failed" error | sherrycp | Outlook - Using Contacts | 1 | July 22nd 06 02:42 AM |
| Resource Scheduling Error "The Operation Failed" outlook 2003. | kunalotron | Outlook - General Queries | 0 | March 21st 06 11:05 PM |
Threaded Mode